Atmel Wireless LAN Access Point User Manual Page 13
- Page / 36
- Table of contents
- TROUBLESHOOTING
- BOOKMARKS
Rated. / 5. Based on customer reviews
Wireless LAN Access Point Configuration
11
Parameters/Buttons Description
Authentication Type
Defines the Access Point’s authentication type. Only the
Wireless Stations that pass the authentication test can
connect to the Access Point.
Open System: any stations can associate with the
Access Point without authentication.
Shared Key: stations using a shared key (the WEP Key
identified by the Access Point) can associate with the
Access Point.
Both: any stations can associate with the Access Point
with or without authentication.
Access Point Name
Enter the Access Point’s name.
Operational Rate Set
By default the Access Point adaptively selects the highest
possible rate for transmission. In case of obstacles or
interference, the system will adjust the speed
automatically. Select the basic rates to be used: 82 84 8B
96 (1-2-5.5-11 Mbps) or 82 84 0B 16 (1-2 Mbps).
Beacon Period
Set the Beacon Period parameter, which specifies the
duration between beacon packets (milliseconds). The
range for the beacon period is between 20-1000 with a
typical value of 100.
DTIM
Determines the interval the Access Point will send its
broadcast traffic. Default value is 4 beacons.
Receive Antenna
Sets which antenna is used for reception. Select Diversity
Antenna for the Access Point.
Transmit Antenna
Sets which antenna is used for transmission. Select
Diversity Antenna for the Access Point.
- User’s Manual 1
- Table of Contents 2
- Chapter 1 Introduction 3
- 1.3 Specifications 4
- 1.4 System Requirement 5
- 1.5 Physical Description 5
- :-13~149°F (-25~65°C) 5
- Back Panel 6
- Introduction 7
- Connection 8
- Configuration 9
- Firmware Upgrade 32
- 4.2 TFTP Client 33
- Chapter 5 Troubleshooting 35
- Troubleshooting 36
Philips 227E3LHSU/00 podręczniki
Instrukcje obsługi i podręczniki użytkownika dla Nie Philips 227E3LHSU/00.
Dostarczamy 1 pdf podręczników Philips 227E3LHSU/00 do pobrania za darmo według typów dokumentów: Instrukcja Użytkownika
Comments to this Manuals